Sun. May 26th, 2024

When it comes to providing a high-speed internet connection, Netgear WiFi range extenders are at par. Users can take the maximum output from their WiFi devices by changing various settings. In order to change the extender’s settings, one needs to access However, not everyone gets success in soothe process. If you are also unable to access, then this article is written for you. Here, we will reveal different troubleshooting tips that will help you get the issue resolved within a matter of minutes. Continue reading.

Fixed: Unable to Access

  1. Reboot the Netgear Extender

Technical glitches are the most common reasons that are preventing you from accessing You can get rid of these glitches by rebooting your Netgear extender. Follow the steps given below to reboot your WiFi device:

  • Disconnect all the WiFi-enabled devices connected to your range extender’s network.
  • Now, unplug your Netgear extender from the wall socket.
  • Wait for some time.
  • Plug your extender back into the wall socket.

Now, check if you are able to access If not, then there might be an issue with the connection between your WiFi devices.

  1. Check the Ethernet Connection

Chances are that the Ethernet cable you are using to connect the extender and router is worn out. So, check for cuts on the Ethernet cable. In case, you find any, get it replaced with a new one as soon as possible.

Besides, make sure that the Ethernet cable is well connected to your Netgear extender and the existing router.

  1. Check the Web Address

A lot of users commit the mistake of typing an incorrect web address into the address bar of the web browser. Looks like you are also following the same path. Remember that the correctdefault web address of the Netgear extender is

Note: If you are logging in to your extender via an Apple device, use mywifiext.local.

  1. Update the Web Browser

Sometimes, it is an outdated web browser that is not allowing you to access Therefore, update the web browser to get rid of the issue. 

In addition, don’t forget to clear the cache, cookies, and browsing history of your web browser before accessing 

  1. Adjust the Extender’s Location

The incorrect placement of your Netgear extender can also be one of the reasons that might be preventing you from accessing Perhaps, you have placed it in a corner or near a concrete wall. Well, it shouldn’t be there. To fix the issue, change the extender’s location. Keep the following points in mind while relocating your extender:

  • Place your Netgear range extender in a neat and clean room.
  • Ensure that your Netgear extender is not placed near reflexive surfaces, metal objects, or radio-waves emitting devices. Such things can create interference in the path of your extender’s WiFi signals.

Now, see if you are still unable to access the mywifiext page.

  1. Reset Your Extender

Followed all the aforementioned troubleshooting hacks, still no luck? It seems that you haven’t configured your extender properly. So, to fix the issue, reconfigure your device. But, before you do that, reset your Netgear extender.

Follow the steps given below to restore your Netgear extender to factory default settings:

  • Ensure that your extender is getting a fluctuation-free power supply.
  • Now, locate the Reset button and press it using a paper clip or an oil pin.
  • Your Netgear extender will get restored to factory default settings.

Now, set up your extender from scratch by accessing the Netgear Genie setup wizard.

Performing login is essential to change the Netgear extender’s settings. We hope that with the help of this article, you will be able to fix the issue you were facing and change the settings of your Netgear extender as per your convenience.

click here for more articles.

By Manali

Leave a Reply

Your email address will not be published. Required fields are marked *